Mipro ACT-818 Wideband Single-Channel Digital Receiver Manual de usuario

ACT-828 Wideband Dual-Channel Digital ReceiverACT-818 Wideband Single-Channel Digital ReceiverUser GuideAll rights reserved. Do not copy or fo

1415EQ: Capsule Equaliser SettingOperating Procedure:1. Press the rotary controller to activate and move the cursor to the EQ parameter. When the EQ c

1617Encryption ( ): to Add or Remove EncryptionEncryption Instructions:1. Press the rotary controller to activate and move the cursor to the icon

1. Press the rotary controller to activate and move the cursor to the icon. When the icon starts to flash, the Lock function is ready to be set.2

Indicates the frequencies did not sync successfully. Ensure the IR windows in both the receiver and transmitter are lined up and can “see” each other,

! Plug one side of the supplied telephone-type cable (RJ-11 connectors) to the REMOTE OUT socket of the on the rear of the receiver and the other end

2425Wideband Digital ReceiversWideband Digital ReceiversTroubleshootingSymptomSolutionsNo Sound! Power-on receiver & transmitter.! Receiver is plu

1. Read these instructions. 2. Keep these instructions.3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. C

1 Product Overview2 Receiver Controls and Indicators - Front Panel3 Receiver Controls and Indicators - Rear Panel4 Receiver Installation6 Rackmount In

Rack-Mount Brackets: Fits into a standard 19-inch rack case. Optional MIPRO FBC-71 rear-to-front cables can be installed for front antenna placement t

45Antenna Installation: ! Install 2 separate antennas on the antenna sockets on the rear panel. illustrated in (Figure 1/Figure 2).Connecting

67Rackmount Installation for ReceiversReceiver Rack-Mount KitsHalf-Rack Unit ReceiverInstall the optional FB-71 rackmount kit & fasten with screws

89All information displays on the same VFD screen.Fully-Lit VFD ScreenReceiver VFD Interface RF Signal Meter (Indicates received signal strength)abcde

1011SQ: Squelch SettingOperating Procedure:1. Press the rotary controller to activate and move the cursor to the SQ parameter. When the SQ cursor s

1. Press the rotary controller to activate and move the cursor to the CH parameter. When the CH cursor starts to flash, the Channel is ready to be set