Mipro ACT-71 Wideband Single-Channel True Diversity Rece Manual de usuario

ACT-71 / ACT-72 / ACT-74Wideband True Diversity ReceiverAll rights reserved. Do not copy or forward without prior approvals MIPRO.Specifications and d

CHANNEL settingSETSELECTFREQUENCY settingCH CursorInstructions:1. Groups 16 contains 2,881 user-defined frequencies. Up to 16 frequencies c

True Diversity ReceiversTrue Diversity Receivers1617NAME settingSETSELECTTurn knob clockwise to increase letters, values, and symbolsTurn knob cou

1. Receiver Lock: Press and hold the Rotary Controller until the “ ” icon appears. Release the Rotary Controller immediately when the “

True Diversity ReceiversTrue Diversity Receivers2021Setting ACT transmitter frequencyThe battery meter is lit when the transmitter is powered on.

1. MIPRO ACT receivers have an advanced computer network-interfaced controlling system.2. Wiring Instructions! The network interface of ACT-71/ACT-72/

True Diversity Receivers2425True Diversity ReceiversRF InterferenceFeedbackSymptom Solutions! Press AutoScan button to locate a clear, interferenc

IMPORTANT SAFETY INSTRUCTIONS WARNINGThis symbol indicates that dangerous voltage constituting a risk of electric shock is present within

The ACT-71/ACT-72/ACT-74 receivers feature a full-color Vacuum Fluorescent Display (VFD) which delivers a very bright light with exceptionally clear c

MIPRO'S PROPRIETARY "ACT" FUNCTION & OPERATIONTrue Diversity ReceiversTrue Diversity Receivers23What is ACT?! “ACT” stands

Rear Panel:True Diversity ReceiversTrue Diversity Receivers45ACT-71 Single-Channel True-Diversity Receiver6108 111214 1315ACT-72 Dual-Channel True

True Diversity ReceiversTrue Diversity Receivers671. Antenna Installation: Install 2 separate antennas on the antenna sockets , on the

RECEIVER OPERATING TIPS!Prior to powering on the receiver, ensure all transmitters are turned off and the mixer's volume control is set to a mini

(Figure 6) (Figure 7)True Diversity ReceiversTrue Diversity Receivers1011! The rack mountable kits are pre-drilled with 4 opening holes to be fitt

NOTE: To confirm a parameter change and save it into the system, you must press the button to end the flashing of the curso